2017-08-09新疆精河Ms6.6地震附近区域相对应变的变化分析     

高丽娟  邢喜民  高歌  李尚伟 《大地测量与地球动力学》2019,39(10):1002-1006

2017年精河M_S6.6地震震前，尼勒克、巴伦台和小泉沟台钻孔应变仪记录到显著的应变变化，经现场落实确认，异常是可靠的。根据这3个台的记录资料计算相对应变的变化，结果表明，地震前最大（小）主应变大小和方向分别出现明显加速和急剧偏转变化。此外还发现，相对应变场异常期间主方向与震源机制解P轴方位较为一致。  相似文献   

桂林-阳朔地区DEM地形特征与岩性相关性分析及分类研究     

陈霄燕  潘军  邢立新  蒋立军  孙也涵  仲伟敬  范博文 《地球信息科学学报》2019,21(12):1867-1876

地形地貌是岩性解译的重要信息,地形因子作为描述DEM数字曲面几何特征的定量指标参数,可用来定量化表达不同岩性所在地区地形地貌特征。本文以桂林-阳朔地区为研究区,研究地形因子数学、地质意义,建立岩性与地形因子组合间的定量关联,进而实现岩石类型划分。本文基于ASTERGDEM提取坡度、起伏度等12个地形因子,在分析各个地形因子地质意义基础上,通过聚类分析及方差分析的多元统计分析方法,研究各岩性地形因子特性及其关联性,建立研究区岩性之间的定量差异;此外,利用因子分析方法研究岩性分类过程中的主导因素,确定适宜岩性分类方法以实现定量化岩性分类。实验结果表明：不同岩性、不同地形地貌的地形因子（组合）之间具有显著差异,基于因子分析得到的宏观地形复杂度指数（MTI）以及微观曲率指数（MCI）对岩石类型的分类精度达77.36%。研究表明,地形复杂度等地形因子可用于岩性分类,采用因子分析方法可获取反映地形地貌宏观、微观特征的定量指标,且岩性分类效果良好。  相似文献   

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

深水铺管船托管架疲劳分析及动态监测点选取研究     

闫宏生  王哲  王晓波  陈永訢  孟祥伟 《海洋工程》2018,36(1):107-113

作为S型铺管作业的关键性装备,托管架长期承受着交变载荷的作用,随着海洋开发向超深水发展,结构疲劳破坏问题不容忽视。采用疲劳谱分析的方法并结合线性累积损伤理论,对托管架结构频域下的变形进行了分析,计算了正常海况下和极端海况下托管架疲劳损伤度并对疲劳寿命进行了评估。研究发现托管架在正常海况下作业符合安全要求,在极端海况下局部结构会受到破坏。并从托管架结构安全监测角度,筛选了结构疲劳分析关键点位,为监测点位的选取提供了依据。  相似文献   

Micromechanical approach to effective viscoelastic properties of micro‐fractured geomaterials          下载免费PDF全文

Cássio B. Aguiar  Samir Maghous 《国际地质力学数值与分析法杂志》2018,42(16):2018-2046

The aim of this paper is to formulate a micromechanics‐based approach to non‐aging viscoelastic behavior of materials with randomly distributed micro‐fractures. Unlike cracks, fractures are discontinuities that are able to transfer stresses and can therefore be regarded from a mechanical viewpoint as interfaces endowed with a specific behavior under normal and shear loading. Making use of the elastic‐viscoelastic correspondence principle together with a Mori‐Tanka homogenization scheme, the effective viscoelastic behavior is assessed from properties of the material constituents and damage parameters related to density and size of fractures. It is notably shown that the homogenized behavior thus formulated can be described in most cases by means of a generalized Maxwell rheological model. For practical implementation in structural analyses, an approximate model for the isotropic homogenized fractured medium is formulated within the class of Burger models. Although the approximation is basically developed for short‐term and long‐term behaviors, numerical applications indicate that the approximate Burger model accurately reproduce the homogenized viscoelastic behavior also in the transient conditions.  相似文献   

基于重力测点和段差变化的前郭5.8级震群研究与三维反演     

王同庆  张品  刘金钊  陈兆辉  张双喜  朱传东 《大地测量与地球动力学》2019,39(5):469-475

利用东北地区近几年流动重力观测数据，分析前郭5.8级震群周边重力点值的时序变化特征，并基于重力段差变化对东北地区整体和局部重力变化引入能够反映异常显著性程度的指标量G和C值，最后对前郭5.8级震群前的重力场动态变化作三维密度反演。结果表明：1）前郭5.8级震群发震构造两侧的局部重力变化具有较明显的差异性，其变化趋势可作为识别构造活化或解耦运动的标志；2）显著性指标量G和C值能够为地震重力前兆的定量描述提供新思路；3）震前重力变化的反演结果显示地震发生在质量运移的过渡区域，垂向反演结果对本次地震的震源深度有一定的揭示意义。  相似文献   

基于SPEI的渭河流域干旱时空变化特征分析          下载免费PDF全文

邹磊  余江游  夏军  王飞宇 《干旱区地理》2020,43(2):329-338

以标准化降水蒸散指数（SPEI）作为评估指标，基于渭河流域28个气象站点1961—2017年实测降水量和气温数据，采用Mann-Kendall（M-K）趋势检验、经验正交函数以及小波变换等方法分析渭河流域干旱时空变化特征，并研究渭河流域干旱与6种大尺度气候因子之间的相关关系，进一步探讨主要气候因子对流域干旱时空分布特征的潜在影响。研究表明：渭河流域在1961—2017年间整体呈现出变旱的趋势。通过经验正交函数分解，渭河流域干旱分布场主要有3种典型模态类型，分别为全局型、西北—东南反向分布型以及东—西反向分布型；同时，大尺度气候因子南方涛动指数SOI与流域干旱分布场具有更好的相关关系，对该区域内干旱变化有较强的影响。  相似文献   

Post-earthquake economic resilience and recovery efficiency in the border areas of the Tibetan Plateau: A case study of areas affected by the Wenchuan Ms 8.0 Earthquake in Sichuan,China in 2008     

Zhou  Kan  Liu  Baoyin  Fan  Jie 《地理学报(英文版)》2020,30(8):1363-1381

Journal of Geographical Sciences - The border areas of the Tibetan Plateau and the neighboring mountainous areas have a high incidence of earthquakes with a magnitude greater than Ms 5.0, as well...  相似文献   

RECENT TECTONIC DEFORMATION ANOMALY AND EARTHQUAKES IN GANSU-NINGXIA-QINGHAI AREA     

Wang Shuangxu  Zhang Xi  Zhang Sixin  Xue Fuping 《大地测量与地球动力学》2003,23(Z1)

1　IntroductionAccordingtogeologicalstructure ,theGansu Ningxia Qinghaiareabelongstothenortheastmar ginofQinghai Tibetblock .Thisareahasbeenpaidmuchattentionby geo specialistsinChinaandabroadbecauseofitssignificanttectonicmovement,itsintensiveseismicity ,anditsimportanceinearth quakehazardmitigation .IntheDevelopmentPro gramonNationalKeyBasicResearchesundertheProject“MechanismandPredictionofContinentalStrongEarthquakes”,themechanismsofcontinen talstrongearthquakesarestudied ,usinghypo…  相似文献